快捷方式：发布信息| 收藏公司

负载阻抗/适用于EMtest BS 200Nx 电子开关

产品/服务：
有效期至：	长期有效
最后更新：	2017-08-30 04:57

单价：

面议

立即询价

(发货期限：自买家付款之日起天内发货)

VIP指数: 0 [第1年]
认证信息:
通过认证

所在地区：

人气：262

详细说明
规格参数
联系方式

“负载阻抗/适用于EMtest BS 200Nx 电子开关”参数说明

是否有现货：	是	认证：	ISO 7637-2:2011
种类：	ISO 7637-2:2004/2011	型号：	负载阻抗/EMtest BS 200Nx
规格：	ISO 7637-2:2011	商标：	EMtest
包装：	全新/二手

“负载阻抗/适用于EMtest BS 200Nx 电子开关”详细介绍

负载阻抗/适用于EMtest BS 200Nx 电子开关

Highlights

Verification load for electronic switch 0.6ohm / 50uH as per ISO 7637-2:2004
Max. supply voltage 28VDC
Max. load current 50A

Additional shunt resistors 10ohm, 20ohm, 40ohm, 120ohm built-in for emission measurement
Over-temperature protected

Application

CA BS 200N - Load Impedance for BS200Nx Electronic Switches

The switching behaviour of the BS 200N series semiconductor switches shall be verified on 0.6ohm to 50uH load inpedance. The CA BS 200N is directly connected to the output of the BS 200Nx. The switching parameters of the BS 200Nx are measured with the load connected. Additionally, the CA BS 200N includes a number of shunt resistors Rs such as 10ohm, 20ohm, 40ohm and 120ohm being required as per standards used during the emission measurement of transients as per ISO 7637-2:2011 and the former ISO 7637-2:2004.

标准

ISO 7637-1:1990
ISO 7637-2:2004

ISO 7637-2:2011

Verification Set-up

Verification of the BS 200N series switching characteristic

As per standard ISO 7637-2 the electronic switch BS 200Nx is requested to meet a rise/fall time specification of 300ns +/-20% in to a defined load of 0.6ohm in series with 50uH.The CA BS 200N is set up in direct proximity to the BS 200Nx with short leads to verify the switching time characteristic. An oscilloscope of sufficient bandwidth is required to properly evaluate the rise/fall time parameters.

Wiring set-up

Set-up of CA BS 200N and BS 200Nx for verification

In order to properly verify the rise/fall time characteristic of the electronic switch (e.g. BS 200N and BS 200N80) it is important to maintain the connection leads as short as possible. EM TEST recommend a maximum length of the connection leads between the CA BS 200N verification load (unit on the left side in the below picture) and the BS 200Nx electronic switch (right side unit in the below picture) of 0.5m.